I separated the jigs and hot glued them to the table for the foam attachment. Note the longerons face out for access and clamping room.
CHAPTER 5 - FUSELAGE SIDES
|
|
||
|
I separated the jigs and hot glued them to the table for the foam attachment. Note the longerons face out for access and clamping room. |
A fuel cell finish nailer, instead of 5 min. epoxy, was used to affix the foam to the masonite. The sides held tight and after glassing pulled off from the jig like a Velcro zipper, leaving only pin sized holes. | ||
|
|
|
 |
 |
|
| The sides, upper and lower longerons glassed. |
The electrical conduit and LWY and LWX pieces. |
 |
||
|
LWY and LWX with foam infill. |